1-11
Getting Started
Starting the PPT 2700
After installing and charging the battery, start the terminal by pressing the red power button.
If the terminal does not power on, reset it. See Performing a Cold Boot on page 2-13.
Figure 1-12. Power Button
As the terminal initializes its unique Flash File system, the Symbol splash screen displays for
about a minute. When the Welcome screen appears, tap anywhere on the screen to continue
to the Align screen.

Aligning the Screen

To align your PPT 2700 so the cursor on the touch screen aligns with the tip of your stylus:
1. If necessary, adjust the contrast on the PPT 2700 so the screen is clear and readable.
See Controlling the Contrast/Backlight on page 2-1 for instructions.
2. Remove the stylus from its storage silo on the back of the PPT 2700.
3. Tap the center of each target that appears on the screen with the tip of the stylus.
Figure 1-13. Tapping the Target
Power
Button
Tap the target firmly and accurately
at each location on the screen. The
target will continue to move until
the screen is aligned.