T+A Elektroakustik K1 CD-RECEIVER Volume Control, Speaker Outputs, SP A ON or SP A OFF

VOLUME CONTROL

 Every time you press the

VOLUME rocker the volume level is reduced () or increased () by 1.25 dB.

If you hold the  rocker pressed in for more than one se- cond, the volume alters continu- ously until you release the rocker again.

Every time you alter the volume, the screen briefly displays the cur- rent value.

SPEAKER OUTPUTS

This button switches the speaker  output  A and/or  B on or off.

If you press one of the buttons, the new status is shown briefly on the alpha-numeric screen, e.g.:

'SP A ON' or 'SP A OFF'

The current status of the loudspeaker outputs is also displayed continuously on the screen in the form of a letter 'A' or 'B'.

Note:

When you switch the system on the speaker outputs are initially switched off. After a short standard delay period speaker output 'A' always switches itself on.

LOUDNESS / LOW BASS EQUALISATION

Short keypress:

Switches LOUDNESS On / Off. Long keypress (approx. 1 sec.): Switcess low bass enhancement On / Off.

SELECTING THE AUDITIONING SOURCE

You select the machine you want to listen to by pressing one of the source buttons. The signal from this source is then reproduced by the system.

At any one time you can only remote-control the machine which is currently selected as the auditioning source. The auditioning sour- ces are selected using the following buttons on the remote control handset:

internal CD player

internal tuner

source device connected to the pre- amplifier input AUX/TV

recording machine connected to the pre-amplifier input TAPE

Note:

When you switch sources the screen shows the newly selected auditioning source briefly. It then reverts to a standard machine-specific display.

13