OPERATING THE AMPLIFIER BY REMOTE CONTROL
GENERAL INFORMATION
In the drawing of the remote control handset shown alongside the buttons marked "" are those which are used to con- trol the amplifier. None of the other buttons have any effect on the amplifier
ON
If the system is already switched on, the button on the re- mote control handset switches the system to stand-by mode.
In stand-by mode the screen just shows the time of day. The time display indicates that the machine is able to respond to remote control signals. However, the power con- sumption of the system is reduced to less than 1 Watt in this mode. Pressing the
button on the handset a second time switches the system on again.
Notes:
•If the system is set to single-room mode (see SETUP functions), the machine reverts to the settings which were in use last time you listened to the system.
•If the system is set to multi-room mode, only the loudspeakers in the room where the user is located are switched on, A in the main room, or B in the secondary room. The volume is limited to "room level" when you initially switch on.