T+A Elektroakustik operating instructions THE CONNECTION TERMINALS OF THE K1 CD-RECEIVER

THE CONNECTION TERMINALS OF THE K1 CD-RECEIVER

SHOCK HAZARD. DO NOT OPEN!

250VA

VOR ÖFFNEN DES GERÄTES NETZSTECKER ZIEHEN!

RC IN

230 V~

50-6 0Hz

R

L

R

IN

L

R

OUT

L

R

L

DIGITAL

MADE IN GERMANY

R

L

ANT

A

FABRIQUE EN ALLEMAGNE

B

AUX / TV

TAPE

SUBW

CD-OUT

1

2

3

4

5

6

7

8

9

 ANT AERIAL INPUT

The system is fitted with a 75 Ω aerial input socket marked ANT which is designed to accept a standard domestic aerial. It also ac- cepts a cable radio connection.

INPUT AUX/TV

Ageneral-purpose pre-amplifier input with an input resistance of 20 kΩ and a variable

input sensitivity of 160 mV, 250 mV, 400 mV or 600 mV.

Note:

To avoid overload the AUX/TV input should be set minimum sensitivity 'MIN' (see am- plifier special function 'SETUP').

IN / OUT TAPE

Input / output sockets for connection to a machine with recording and playback facili- ties (recorder).

When you are connecting a recorder note that the INPUT sockets on the recorder must be connected to the OUT sockets on the system, and the OUTPUT sockets on the recorder to the IN sockets on the system.

SUBW

Output socket to connect an active subwoofer

A (Loudspeaker terminals)

Connect the main loudspeakers to this termi- nals. The impedance of each speaker must not be lower than 4 Ω.

DIGITAL CD-OUT

Digital output of the internal CD player for the use of coaxial digital leads.

B (Loudspeaker terminals)

Connect the loudspeakers located in the sec- ondary room to the  B terminals (Remote Speakers). The impedance of each speaker must not be lower than 4 Ω.

Note:

It is important to check that the terminal clamps are firmly screwed down, and that there is no chance of short-circuits due to projecting strands of wire.

Note:

If the loudspeakers are to be used in coun- tries outside the EU the red/black stoppers can be removed from the loudspeaker termi- nals. The speakers can then be connected using banana plugs.

The stoppers are simply a push-fit in the ter- minals, and can be prised out from the rear using a suitable tool such as a knife blade.

44