T+A Elektroakustik K1 CD-RECEIVER operating instructions Trouble-Shooting

TROUBLE-SHOOTING

Many problems have a simple cause and a correspondingly simple solution. The fol- lowing section describes a few difficulties you may encounter, and the measures you need to take to cure them.

If you find it impossible to solve a problem with the help of these notes please disconnect the unit from the mains and ask your author- ised specialist dealer for advice.

Problem:	Machine does not switch on
	(screen	and	symbol	over
	button not glowing).
Cause:	Mains lead not plugged in cor-
	rectly.
Remedy:	Check connections, push			plugs
	in firmly.
Problem:	Whistling	or	hissing sounds
	from the speakers.
Cause:	The aerial lead is too close to
	the mains lead or the Cinch ca-
	bles.
Remedy:	Re-position the cables and keep
	them well apart. Use the house-
	hold aerial or a radio cable.
Problem:	System responds correctly to
	manual operation of the but-
	tons, but does not react to re-
	mote control commands.
Cause1:	Incorrectly inserted batteries or
	flat batteries in the remote con-
	trol handset.
Remedy:	Re-fit batteries correctly or fit
	new ones.

Cause2:	No visual contact between sys-
	tem and remote control trans-
	mitter.
Remedy:	Ensure direct line-of-sight con-
	tact to the remote control trans-
	mitter.
	Note that glass doors may pre-
	vent the system working prop-
	erly.
	Maximum	range	between
	transmitter and receiver approx.
	6 metres.
	Position the system in such a
	way that the RC receiver and the
	optional E 2000 is not subjected
	to direct sunlight or strong arti-
	ficial lighting.
	Fluorescent and energy-saving
	lamps are powerful sources of
	interference.
Cause3:	You are using an incorrect ver-
	sion of the optional E 2000 re-
	mote control receiver. The cor-
	rect type of receiver has two
	exposed screw heads on the un-
	derside of the case.
Remedy:	Please refer to your  spe-
	cialist dealer.

52