VideoPortal | TANDBERG D1320202 manual

TANDBERG GW

Data port Command Interface User Guide

VideoPortal

Registers the 3G Gateway with the VideoPortal

NOTE! The GW needs to reboot before the changes will take effect.

Mode <On/Off> or

System [1 .. 2] IP Address <IPAddr>

---

sub-commands:

•Mode: If Mode = On the 3G Gateway is registered with 1 or 2 video portals

•Address: IP address of the Video Portal the 3G Gateway is to be registered to.

Example of VideoPortal feedback:

*c xConfiguration VideoPortal Mode: On

*c xConfiguration VideoPortal System 1 Address: "10.31.1.8"

*c xConfiguration VideoPortal System 2 Address: "127.0.0.1"

20

Image 20

TANDBERG D1320202 manual VideoPortal, Mode On/Off or System 1 . IP Address IPAddr

Contents

Tandberg 3G GW D1320202 Table of Contents Introduction Tandberg GW Hardware and Cabling Troubleshooting Connecting to the Data port Command Interface using Telnet Command format Command typesIntroduction Xconf H323Gatekeeper ? Xconf telnet mode CommandsXconf telnet mode on System Configuration Commands Command Description H323GatekeeperH323CallSetup H323CallSetup Mode Direct/Gatekeeper Isdn EthernetEthernet speed Snmp HttpsHttp SSH Telnet Tandberg GW General GW Commands Command Description Gateway NTP SIP Tandberg GW Example of SS7 feedback Tandberg GW Mode On/Off or System 1 . IP Address IPAddr VideoPortal System Status Commands TemperatureCelciusTemperatureFahrenheit PRI DNS URL Status Address PortAddress Protocol BRI PRI Feedback 1 FeedbackGatewayCall Status Status Address Port Last Update Last Correction SystemLoadSystemLoad Call 1 Call Debug Commands Special Commands Error Result parameters ParametersExpression 1 . S 0, 256 XPath expression OK Result parameters ServiceEntryDelete Parameters ServiceEntryNumberr Example Delete Service nrServiceEntrySwap OptionKeyDelete Xhistory ? ExamplesXhistory Tandberg GW Index Commands