TATUNG TDR series Digital Recording System | Page | 18 |
|
|
|
3.5 Motion
This function button (as shown below) can be used to setup the motions.
Note: If no detection zone was defined, system will recognize the whole windows as a detection zone.
Note: After the camera is motion activated in Schedule Setup Mode and after the detect zone is set, this channel will be motion-
beactivated in the define area. If anything falls in this area, the detected motion will be seen in a lot of small blue squares. And red wording “MOTION DETECTION” will be blinking.
Click on this button to setup the motion, the screen display as the below (Please following the 4 steps)
1.Select channel
Select the channel from 1 to 16.
2.Set up motion detection zone.
Setup the motion detection zone for each channel by click and drag. It would be seen in red square (Maximum 10 areas per camera).
3.Set up the MISC options.
Motion beep
In motion recording mode, BEEP sound (if the speaker was included in the system) can be activated/inactivated by checking the box or not. Beep time can also be adjusted by dragging the cursor.
