22 Models 8752, 8756, 8757Operating Procedures
Step 3
Assemble the freezer door. Place the large rubber
gasket(s) in the groove(s) on the back side of the
freezer door.
Slide the white plastic front bearing(s) over t he baffle
rod(s), making certain that the flanged end of the
bearing is resting against the freezer door. DO NOT
lubricate the gasket(s) or front bearing(s).
Figure 6
Note: There are two gaskets and two front bearings
for the Models 8756 and 8757 door, one for each
freezing cylinder.
Slidethe o- r ings into the grooves on the prime plug(s).
Apply an even coat of lubricant to the o -rings and
shaft(s).
Figure 7
Note: There are two prime plugs for the Models 8756
and 8757 door, one for each freezing cylinder.
Insertt he prime plug(s) into the hole(s) at the top of the
freezer door and push down.
Figure 8
Step 4
Install the freezer door. Insert the baffle rod(s) through
the beater(s) in the freezing cylinder(s). W ith the door
seated on the freezer studs, install the handscrews.
Tighten equally in a criss- cross pattern to insure the
door is snug.
Note: On the Models 8756 and 8757, the short
handscrews go on the bottom and the long
handscrews go on the top.
Figure 9