24 Models 8752, 8756, 8757Operating Procedures
Step 7
Snap the design cap over the bottom of each door
spout.
Figure 14
Step 8
Install the rear drip pan. Slide the rear drip pan into the
hole in the side panel.
Figure 15
Step 9
Install the front drip tray and the splash shield beneath
the door spout(s).
Figure 16
Air/Mix Pump Assembly
The purpose of the air/mix pump is to meter a specific
amount of air and mix and transfer this combination to
the freezing cylinder.
Refer to the illustration on page 28 for identif ication of
parts during assembly.
Step 1
Assemble the piston. Slide the o- ring into the groove
on the piston. DO NOT lubricate this o-ring.
Figure 17
Step 2
Assemble the liquid valve body. Slide the three check
bandsand t hree o- rings into the grooves on the liquid
valve body. DO NOT lubricate the check bands or
o-rings.
Figure 18