20 Model C300 NPOperating Procedures
Step 13
Place the large rubber gasket into the groove on the
back side of the freezer door.
11324
Figure 18
Step 14
Slide the white, plastic front bearing onto the bearing
hub, making certain that the flanged end of the
bearing is resting against the freezer door. DO NOT
lubricate the door gasket or front bearing.
11325
Figure 19
Step 15
Position the freezer door onto the four studs on t he
front of the freezing cylinder and push the door into
place. Install the four handscrews onto the st uds
and tighten them equally in a crisscross pattern to
insure that the door is snug. DO NOT over-tighten
the handscrews.
Note: If the freezer door does not fit into place
easily, position the open end of the beater assembly
in the 11 o'clock position.
11326
Figure 20
Step 16
Position the baffle arm by inserting it down into the
hole on the baffle assembly which protrudes from
the door. Verify proper installation by moving the
baffle assembly back and forth to be sure it moves
freely.
11327
Figure 21
Repeat Steps1 through 16 for the remaining
freezing cylinder(s).