23
Model C302 O perating Procedures
Step 14
Install the prime plug. Place the two o-rings on the
prime plug and lightly lubricate.
Figure 20
Figure 21
Step 15
Place the large o-ring into the door groove and
lightly lubricate.
Figure 22
Note: Every four months or less, discard t he o-rings
and install new o-rings.
Step 16
Install the front bearing. Do not lubricate the front
bearing.
Figure 23
Step 17
Install the freezer door. Position the door on t he four
studs on the front of the freezing cylinder. Firmly
push the door into place. Install the four handscrews
on the studs and finger-tighten them equally in a
criss-cross pattern to insure that t he door is snug.
Do not over-tighten the handscrews.
Figure 24
Step 18
Repeat Steps1 through 17 for the other freezing
cylinders.