16 Models 150, 152, 162, 168Important: Tothe Operator
090526
Reset Button
If an overload condition occurs, the freezer will
automatically stop operating. To properly reset the
freezer, place the toggle switch in the “OF F” position.
Waittwo or thr ee minutes; then press the reset button.
Place the power switch in the “WASH” position and
observe the freezer’s performance; place the power
switch in the “AUTO” position.
Note: If the freezer is unplugged from the wall
receptacle, it will be necessary to press t he reset
button for the freezer to operate once power is
re- established.
Power Switch
The center position is “OFF”. The left position is
“WASH” which activates the beater motor only. The
right position is “AUTO”, which activates the beater
motor and the refrigeration system.
Feed Tube
The models 150, 152, 162 and 168 are called upon to
handle a large variety of products (i.e., soft serve,
yogurts, Italian ices, sherbets, etc.). Thus, the
consistency of the mix you use will vary. The feed tube
meters a combination of mix and air into the freezing
cylinder.I f not enoughmix ent ersthe fr eezingcylinder,
a freeze- up may occur, which will cause eventual
damage to the beater. Depending upon the product
being run, you may wish to contact your local
authorized Taylor Distributor to make a slight
adjustment in the feed tube.
Figure 10
Note: During “AUTO” operation, the orifice end of the
tube should be inserted in the hole in the hopper.
Taylor Quality Control
Theseunits use a solid state control called the T.Q.C.
The purpose of this solid state control is to sense the
viscosity (thickness) of the product in the freezing
cylinder.W ith the power switch in the “AUTO” position,
the T.Q.C. will automatically keep the mix in the
freezing cylinder at the proper viscosit y and ready for
serving.
Indicator Light - “Mix Low”
A mix level indicating light is located at the front of the
unit. When the light is on, it indicates that the mix
hopper has a low supply of mix and should be r efilled
as soon as possible. Always maintain at least 2” (5. 1
cm) of mix in the hopper. If you neglect to add mix, a
freeze- up may occur. This will cause eventual
damage to the beater assembly and to the fr eezer
door.
Mix RefrigerationSwitch
The mix refrigeration switch is located under the
control channel and is used for several purposes:
1. For the unit to operate in the “AUTO” mode, the
mix refrigeration switch must be “ON”.
2. For the separate hopper refrigeration system t o
operate, the mix refrigeration switch must be in
the “ON” or the “STANDBY” position.
3. For t he cylinder temperature retention system to
operate, the power switch must be in the “ AUTO”
position and the mix refrigeration switch must be
in the “STANDBY” position.
Separate Hopper Refrigeration(SHR)
This feature incorporates the use of a separate small
refrigeration system to chill (on a limited basis) and to
maintain the mix in the hopper to under 40_F(4.4_C)
and assuresbacterial control. To activate this system,
place the power switch in the “AUTO” position and the
mix refrigeration switch in the “ON” position. To oper-
ate this system in the “STANDBY” mode, place the
power switch in the “AUTO” position and the mix refr i-
geration switch in the “STANDBY” position.