Preset changes are not seamless

-To obtain perfect seamless update when changing presets, I/O and Utility settings must be the same in both presets.

You press the POWER switch but there is no light. - The POWER switch on the rear panel is switched off.

The Input PPM meters do not peak out.

-You are using Analog Inputs, but the Input selector in the I/O menu is set to Digital in.

-The Analog Input level is set too low.

No sound through the D22.

-You are using Analog Inputs, but the Input selector in the I/O menu is set to Digital in.

- Hold the POWER key pressed for at least 3 seconds.

Image 23

Contents

USER’S Manual Page Service Important Safety Instructions Certificate Of Conformity For the customers in Canada Table of Contents Page Introduction Main Features Front Panel Power & Memory Card Electronic Power switch »Easy touch« Bypass Jack unbalanced XLR Output Balanced XLR XLR Rear Panel Signal path is 24 bit Signal Flow Output Analog Input Analog SetupsInstallation note Input Analog Input Digital Sample Rate Sync Sample Rate Conversion On Input Analog Sample Rate SyncInput Digital Sample Rate EXT DI Basic Operation Keyboard Lock Function Control Adjust wheelBypass Bypasses the unit Recall Recalling a presetPresets In General Fader Locked modeSeamless preset changes Store Storing User PresetsUsing a Memory card Dither SetupSample Rate Conversion Clock Digital I/O Press the I/O key twice to enter this AnalogAnalog Out Utility Time ResolutionControl Resolution Tap Delay Meter Memory BackupGPI External Input No sound through the D22 Preset changes are not seamlessYou cannot turn the power off Appendix Technical specifications Key test Delay + Control wheel testBattery test Service note Compressor Overshoot Sys-Ex System Exclusive Midi CommandsTos-link Bits & Bytes Fader Cable Midi CablePedal Cable Jack unbalanced XLR Output Jack balanced XLR Examples Frequently Asked Questions Activating the Master Fader Why make a Master Fader?Connecting and Calibrating the Master Fader Master Fader