83
-
5
15
-
0
00
Rev.
B

13

Gene
sys
TM
power supplies generate magnetic fields, which might affect
the operation of other instruments. If your equipment is su
s
ceptible to
magnetic fields, do not position it adj
a
cent to the power supply.
WARNING
To avoid electric shock hazard, do not insert co
n
d
uctive parts
through the front panel slits.
CHAPTER 3 INSTALLATION

3.1 GENERAL

This Chapter contains instructions for initial inspection, preparation for use and repackaging for shi
p-
ment. Connection to PC, setting the communication port and linking Genesys
TM
power supplies are
d
e
scribed in Chapter 7.

3.2 PREPARATION FOR USE

In order to be operational the power supply must be connected to an appropriate AC source. The AC
source voltage should be within the power supply specification. Do not apply power before reading
Se
c
tion 3.3, 3.6 and 3.
7.
Table 3
-
1 below, describes the basic setup procedure. Follow the instructions in Table 3
-
1 in the s
e-
quence given to prepare the power supply for use.
Step no.
Item
Description
Reference
1
Inspection
Initial physicalinspection of the power su
p
ply
Secti
on 3.3
2
Installation
Installing the powers upply,
Ensuring ad
e
quate ventilation.
Section 3.4
Section 3.5
3
AC source
AC source requirements
Connecting the power supplyto the AC source
Section 3.6
Section 3.7
4
Test
Turn
-
on checkout procedure.
Section 3.8
5
Load conne
c
tion
Wire size selection. Local/Remote sensing. Single
or multiple loads.
Section 3.9
6
Default setting
The power supplys ettingat shipm ent.
Section 7.2.1
Table 3
-
1: Basic setup procedure

3.3 INITIAL INS

PECTIONS

Prior to shipment this power supply was inspected and found free of mechanical or electrical defects.
Upon unpacking of the power supply, inspect for any damage, which may have occurred in transit.
The inspection should confirm that there is no ex
terior damage to the power supply such as broken
knobs or connectors and that the front panel and meters face are not scratched or cracked. Keep all
packing material until the inspection has been completed. If damage is detected, file a claim with ca
r-
rier
immediately and notify the
TDK
-
Lambda Americas Inc.
sales or authorized service facility nearest
you.
WARNING
The Genesys
TM
series is intended onlyf or installationin Restricted
Access Location (RAL). Access to Hazardous parts (rear side of
the power supply)shall be prevented after i
n
stallation.