EDigital audio output terminals

Digital audio from DVD-Video, CD and video CD is output from these terminals.

The unit may be connected using either coaxial or optical (TOS) commercially available cables to amplifiers including a decoder, or to digital audio devices such as CD recorders, etc.

COAXIAL: Use RCA (pin) digital audio cable

OPTICAL: Use optical digital audio cable (TOS)

<Keep the supplied cap to cover the OPTICAL terminal when it is not in use.

<Select “ALL” or “PCM only” in the Digital Audio Setup (see page 34).

FAUX 1/LINE OUT jacks

Analog 2-channel audio signal is input or output from these jacks. Connect a cassette tape deck etc. to these jacks using commercially-available RCA cables.

Make sure to connect:

white plug q white jack (L: left channel)

red plug q red jack (R: right channel)

GPower cord receptacle

After all other connections have been made, insert the supplied AC power cord into this receptacle, then connect the other end of the power cord into the wall socket. Ensure that your AC voltage corresponds to the voltage marked on the rear panel of the unit. Consult a qualified electrician if you are in doubt.

<In order to avoid the risk of electric shock, fire, and so on, only use the supplied power cord.

<If you are not going to use the unit for some time, disconnect the power cord from the wall socket.

Remote Control Unit

The provided Remote Control Unit allows the unit to be operated from a distance.

When operating the remote control unit, point it towards the remote sensor on the front panel of the unit.

<Even if the remote control unit is operated within the effective range (5m), remote control operation may be impossible if there are any obstacles between the unit and the remote control.

<If the remote control unit is operated near other products which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the other products may operate incorrectly.

Battery Installation

ENGLISH

 

1.Remove the battery compartment cover.

2.Insert two “AAA” (R03 or UM-4) dry batteries. Make sure that the batteries are inserted with their positive “+” and negative “_” poles positioned correctly.

3.Close the cover.

Battery Replacement

If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones.

Precautions concerning batteries

<Be sure to insert the batteries with correct positive “+” and negative “_” polarities.

<Use batteries of the same type. Never use different types of batteries together.

<Rechargeable and non-rechargeable batteries can be used. Refer to the precautions on their labels.

<When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones.

<Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire.

11