Settings (Video Setup Page)
Video Output

S-VIDEO

Select this when your TV or monitor is connected to the S- VIDEO terminal.

Y Cb/Pb Cr/Pr

Select this when your TV or monitor is connected to the COMPONENT VIDEO terminals.

TV Mode

This setting is available only when “COMPONENT” is set to “Y Cb/Pb Cr/Pr”.

This setting allows the selection of interlaced (INTERLACE) or progressive-scan (P-SCAN) video from the component video outputs.

Progressive-scan video provides a better, clearer picture. However, it is not supported by every television or monitor, and you should ensure that this is supported fully before turning on this option.

<When your TV isn’t compatible with progressive scan, never select “P-SCAN”. No picture will be shown on the monitor.

In case you select “Progressive” by mistake, connect your TV via the VIDEO OUT jack or S-VIDEO jack to display the Setup menu and change the setting to “INTERLACE”.

‘CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COMPATIBLE WITH THIS PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF 480 (525) OR 576

(625)PROGRESSIVE SCAN PICTURE PROBLEMS, IT IS RECOMMENDED THAT THE USER SWITCH THE CONNECTION TO THE ‘STANDARD DEFINITION’ OUTPUT. IF THERE ARE QUESTIONS REGARDING OUR TV SET COMPATIBILITY WITH THIS MODEL 480p (525p) AND 576p (625p) DVD PLAYER, PLEASE CONTACT OUR CUSTOMER SERVICE CENTER.’

Color Setting

1. Highlight “Color Setting” and press the right button.

 

2. Use the up and down buttons to select the parameter.

 

Sharpness

 

Adjusts the sharpness of the picture shown on the

 

monitor.

 

Select HIGH, MEDIUM or LOW using the cursor buttons,

 

and press the ENTER button.

 

Brightness

 

Adjusts the brightness of the picture

 

 

Use the left and right buttons to change the value, and

ENGLISH

Contrast

press the ENTER button.

 

Adjusts the picture contrast

 

Use the left and right buttons to change the value, and

 

press the ENTER button.

 

Gamma

 

Adjusts the gamma value of the picture

 

Select HIGH, MEDIUM, LOW or NONE using the cursor

 

buttons, and press the ENTER button.

 

Hue

 

Adjusts the green/red balance of the picture (only for

 

progressive-scan and S-Video output)

 

Use the left and right buttons to change the value, and

 

press the ENTER button.

 

Saturation

 

Adjusts the saturation level.

 

Use the left and right buttons to change the value, and

 

press the ENTER button.

 

Luma Delay

 

Adjusts the luma delay.

 

Select 0T or 1T using the cursor buttons, and press the

 

ENTER button.

 

3. Press the left button when done, to return to the Video

 

Setup Page.

 

35