This function allows you to make uninterrupted recordings on both sides of two tapes.
1Load cassette tapes for recording into the TAPE I and TAPE II compartments.
Side “A” facing you
2Set the REV MODE switch to the p (CONT REC/PLAY) position.
Set the DOLBY NR switch to the ON position if you want to.
3Press the TAPE I deck’s RECORD (K) key.
The deck enters the 
will light on the display. Now adjust the recording level and any other settings, as required.
4Check the recording direction.
If an indicator is lit which points in the direction opposite to the one desired, change the direction by pressing the opposite direction PLAY (hor y) key.
NOTE
Be careful not to press the PLAY (h or y) key whose arrow points in the same direction as the indicator. Doing so will start recording.
Recording is done in this order: | ||
TAPE I | Side “A” | |
|
| x |
|
| Side “B” |
|
| x |
TAPE II | Side “A” | |
|
| x |
|
| Side “B” |
You can start recording from side “B” of TAPE I. But if you do so, | ||
side “A” of this tape is not recorded: when recording reaches the | ||
end of side “B”, the TAPE II deck starts recording. | ||
|
| ENGLISH |
NOTE |
| |
|
| |
The TAPE II deck always starts recording from side “A”.
5Start recording.
Recording starts when you press the PAUSE key or the PLAY (h or y) key whose arrow points in the same direction as the indicator on the TAPE I deck.
When recording is finished on the TAPE I deck, the TAPE II deck automatically starts recording.
NOTE
The transition from TAPE I to TAPE II takes several seconds.
ATo stop recording
Press the STOP (H) key of the deck which is currently recording.
17