NOTE

High-speed dubbing makes a copy at approximately two times the normal speed. We recommend normal speed dubbing for best audio quality.

During dubbing, either the NORM DUB or HIGH DUB indicator lights steadily on the display.

During normal speed dubbing, only the following keys work:

TAEP I deck

: STOP (H)

TAPE II deck

: PAUSE, REC MUTE, STOP (H)

During high-speed dubbing, only the STOP (H) key works.

Neither DUB START key works immediately after the tape is fast- forwarded or rewound to the end. Wait for 5 seconds or more before pressing the key.

NOTE

<During dubbing, the pitch control does not work.

<Recording level adjustment is not necessary for dubbing, as the recording level is set to the level of the pre-recorded tape. Operating the REC LEVEL control, before or after starting dubbing, has no effect at all.

<If a nearby television set is switched on during high-speed dubbing, a high-pitched interference noise may be recorded on the tape. To avoid this, either perform dubbing at normal speed, or turn off the television.

<If you want to start dubbing using the remote control unit, press the two DUB START keys (NORMAL keys or HIGH keys), for either normal or high speed dubbing, on the remote control unit at the same time.

Editing during dubbing (only at normal speed)

You can prevent unwanted songs or unnecessarily long blanks from being dubbed, or you can create blanks between songs.

1. At the desired point during dubbing, press the PAUSE key

 

 

on the TAPE I deck. The TAPE II deck only enters the pause

ENGLISH

mode, allowing you to let unwanted songs go by.

 

To create a 4-second blank between songs, press the REC MUTE

 

key on the TAPE II deck. The TAPE II deck temporarily stops after

 

recording no signal for 4 seconds.

 

The TAPE I deck continues playback when the TAPE II deck is in

 

 

pause mode.

 

2. To resume dubbing, press the PAUSE key on the TAPE II

 

deck.

 

19