Recording
This function allows you to record the same material simultaneously on both TAPE I and TAPE II.
Load tapes into both decks and press the PARALLEL REC key to start recording.
Before starting recording, check and correct the following by performing steps 1 – 7 on page 14 such as Record direction, Reverse mode setting, Dolby NR setting, Recording level, etc.
When everything is ready, get back into stop mode if the deck is in another mode.
During parallel recording, the PARALLEL indicator is lit on the display. During parallel recording, only the following keys work:
TAEP I deck : STOP (H)
TAPE II deck : PAUSE, REC MUTE, STOP (H)
Pressing the STOP (H) key on either deck stops both tapes at once.
1Insert a cassette tape for playback into the TAPE I compartment and a cassette tape for recording into the TAPE II compartment.
Side “A” facing you
2Set the tape transport direction on both decks.
If the play/record direction indicator (h / y) on the display points in the direction opposite to the one desired, press the PAUSE key followed by the PLAY (h or y) key corresponding to the desired direction.
After changing the tape transport direction, be sure to press the STOP (H) key to get out of the pause mode.
NOTE
<Be careful not to press the PLAY (h or y) key whose arrow points in the same direction as the indicator. Doing so will start playback.
<Set the REV MODE switch as required.
<You don’t need to adjust the recording level or set the Dolby NR system, as both depend on the
3Press either DUB START key to start dubbing.
normal speed | |
dubbing start | dubbing start |
For normal speed dubbing, press the NORMAL key. For high- speed dubbing, press the HIGH key.
18