Chapter 4

Voice over IP

4.1 Telephony Setup

Telephony installation The SpeedTouch™ is equipped to connect one or two analogue phones or faxes.

 

1

2

3

4

 

 

1

 

2

 

2

 

 

 

3

 

 

 

 

USB

1

ETHERNET

 

4

DSL

PSTN

PHONE

RESET

 

 

 

Use a phone cable with RJ-11 connectors to:

1Wire the SpeedTouch™ Phone port(s) to your phone(s) or fax.

2If your SpeedTouch has a black-coloured port labeled "PSTN", you must connect this port to the telephone output of your DSL splitter to allow regular phone calls with the same telephone set. In the other case, no additional connections are needed.

!

!

This is only required if you still want to make phone calls using the regular telephone line.

Be aware that, if the PSTN port (if provided) is not wired to your telephone wall outlet or distributed filter, emergency calls are not always possible!

As distributed filters are country-specific, you cannot use the device everywhere.

Telephony configuration The telephony service might already have been configured on your SpeedTouch™ during initial setup.

If not, follow the instructions below:

Enable the telephony service

Configure the telephony service

Your Internet connection must be up and running before you can configure

Internet telephony.

38

E-DOC-CTC-20051017-0153 v1.0