Details of a security level
Chapter 5
SpeedTouch™ Web Interface
To view the details of the currently active security level:
1In the Toolbox menu, click Firewall.
2Click the Details link.
Following information is provided per rule that is part of the security level The name of the rule
The Action that is applied on the traffic when the rule is valid
The Source and Destination interface or IP address (range) to which the rule applies
The protocol or SpeedTouch™ Service for which the rule applies.
The number of Hits (number of times that the rule was applied to traffic).
Creating a new security level
Proceed as follows:
1In the Toolbox menu, click Firewall.
2In the upper right corner, click Configure.
3In the Pick a task list, click Create a new Security Level.
4In the Name box, type a name for the new security level.
5Choose an existing security level to clone from.
6Click Apply.
Editing a security level Proceed as follows:
1In the Toolbox menu, click Firewall.
2In the upper right corner, click Configure.
3Select a security level, and then click the Edit link.
The firewall settings of the selected security level appear.
4You can:
Select a row using the Edit link to modify the security rule.
Click Add to create a new security rule.
5Edit or define following parameters of the rule: The Name of the security rule
The Source Interface and IP Address (range)
Use Any as IP address in case all traffic for the interface should be parsed.
Or you can type a
The Destination Interface and IP Address (range)
Use Any as IP address in case all traffic for the interface should be parsed.
Or you can type a
The Service type of the traffic; this can be a protocol (dns, smtp, ...) or a specific SpeedTouch™ system service.
81 | |
|