Technicolor - Thomson PT-AE2000E manual Installation, Sleep, Altitude, Lamp Power, Lamp Runtime

OPTION menu

INSTALLATION

When installing the projector, select the projection method according to the projector position. Press I H to cycle through the options. See “Projection method” on page 15.

FRONT/DESK	Setting on a desk/floor and
	projecting from front
FRONT/CEILING	Mounting in the ceiling and
	projecting from front
REAR/DESK	Setting on a desk/floor and
	projecting from rear
REAR/CEILING	Mounting in the ceiling and
	projecting from rear

SLEEP

You can select the required duration of time and set the off timer to turn off the power of the projector automatically. 3 minutes before turn-off, the countdown of minutes will be displayed in the lower right corner. Press I H to cycle through the options. See “Switching off the projector automatically” on page 25.

ALTITUDE

If you use the projector at high elevation, the ALTITUDE setting need to be HIGH to set the fan speed high. Press I H to select the required option.

LOW	The fan speed is low.
HIGH	The fan speed is high.

NOTE:

•At 1 400 m (4 593 ft) above sea level, the setting must be HIGH.

•The loudness of fan noise depends on the ALTITUDE setting.

LAMP POWER

You can adjust the power of the lamp to save on electricity, prolong the lamp life and reduce the noise.

Options	Function
NORMAL	When higher luminance is
	required.
ECO-MODE	When lower luminance is
	sufficient.

NOTE:

•When no input signal is detected, the function is disabled.

LAMP RUNTIME

You can check how long the lamp has been used.

NOTE:

•LAMP RUNTIME is a relevant matter for lamp replacement timing. See “Replacing the lamp unit” on page 44.

Settings

ENGLISH - 41