Setup, Conﬁguration, Active Channels | Technika 42-2030 instruction

Setup

The adjustments in this menu are given as the following:

Conﬁguration

You can conﬁgure the settings of your TV. Select Conﬁguration from Setup menu and press OK to view this menu. Press the RETURN button on the remote control to exit.

Active Channels

You can select broadcasts to be listed in the channel list. To display speciﬁc types of broadcast, you should use active channel list setting. Select Active channel list by using “” or “” button. Press OK button to continue.

Scan Encrypted

Scan Encrypted Channel feature will always be YES after performing ﬁrst time installation. When this setting is on, search process will locate the encrypted channels as well. If it is set as NO manually, encrypted channels will not be located while in automatic search or manual search. Use “” or “” button to select Scan Encrypted and then press “” or “” button to set this setting as Yes or No.

Output Settings

You can use this option to conﬁgure output settings.

AC3 Audio

Highlight the AC3 Audio item by pressing “” or “” buttons. Use the “” or “” buttons to set the AC3 Audio as On or Off.

If the channel that you are watching supports AC3 Audio, turn this setting on.

SPDIF Delay

You can use this setting when there is an synchronization problem in the received broadcast. Press “” or “” button to change the delay or use numeric buttons to enter SPDIF Audio delay manually. When ﬁnished, press GREEN button to apply.

SPDIF Audio

Use this setting to deﬁne digital audio out signal type. Use “” or “” buttons to set SPDIF Audio as Bitstream or PCM. If your selected channel includes Bitstream sound stream, you should connect your TV to external equipment by using spdif out of your TV for enabling the sound output. If you have no external sound equipment, please select Digital Audio Out as “PCM” by using “” or “” button.

Receiver Upgrade

Over Air Download (OAD)

To ensure that your TV always has the most up to date information, use this setting. Please ensure that the TV is set to standby mode. The TV automatically powers up at 3.00 A.M. each day and searches for any new information which may be broadcast and will download this to your receiver automatically. This operation will normally take approximately 30 minutes. If you have an important recording to be carried out at

3.00A.M. and you do not want to interrupt it, disable auto OAD search by performing the following:

•Press MENU button and using the “” or “” buttons to choose Setup and press OK button.