Paradyne 8540, 8546 Initial Setup Instructions 3

3-1
8000-A2-GB20-20 November 1997
Initial Setup Instructions 3
Overview
This chapter provides instructions on how to access the system for the first time
and perform initial setup instructions.
NOTE:
It is highly recommended that you read the HotWire DSLAM for 8540 and
8546 DSL Cards Network Configuration Guide
before you attempt to
configure the system. The Network Configuration Guide provides worksheets
to help you plan and configure your network.
Accessing the System for the First Time
When you power on the HotWire DSLAM for the first time, the system displays
the Who Am I screen on the console terminal. On this screen, you must set the
management IP address and subnet mask for the MCC card. Follow the
instructions in the following section,
Setting the Management IP Address and
Subnet Mask on the MCC
.
Setting the Management IP Address and Subnet
Mask on the MCC
After powering on the system for the first time, set the management IP address
and subnet mask of the MCC card. This is a mandatory step and must be
completed before proceeding to Chapter 4,
Configuring the HotWire DSLAM .