Paradyne 8546, 8540 manual System Does Not Recognize New DSL Cards, Large Number of Traps

Diagnostics and Troubleshooting

System Does Not Recognize New DSL Cards

PROBLEM: System does not recognize new DSL cards with new addresses (Addresses not pre-configured on MCC card).

ACTION: 1. Configure new DSL cards from MCC screen.

2.Restart s1b interface (see Configuration → DSL Cards (A-G) in Chapter 6).

3.Reset DSL card from the MCC screen (see Configuration → DSL Cards (A-G) in Chapter 6).

4.Pull the card out and push it back in.

Large Number of TRAPS

PROBLEM: DSL cards not using MCC Router ID as source address for traps.

ACTION: 1. In standard configuration, MCC and DSL are in separate subnets and Router ID is the same as IP Base Address of MCC's LAN (e1a) interface. Set the Router ID to the management IP address on MCC's LAN interface.

2.Set this as ªBase IP Addressº for LAN interface.

3.Reset MCC and all cards (see Configuration → DSL Cards (A-G) in Chapter 4).

Cannot Communicate with Interface

PROBLEM: Cannot communicate with Ethernet or other interface after adding, changing, or deleting IP addresses on DSL or MCC card.

ACTION: 1. When you add, change, or delete addresses on a DSL card, you must restart that interface (see Configuration → Interfaces (A-C) in Chapter 6).

8-14 November 1997 8000-A2-GB20-20