Monitoring the HotWire DSLAM

Table 7-9. Network Protocol Options (7 of 7)

PPP Stats (General)

B-D-H (A)

 

 

Displays a summary of the PPP activity on a selected interface on the card.

Interface Name ± Enter the name of the desired DSLinterface (s1c, s1d, s1e, s1f). Link Phase ± Current phase/state of this link (Init, Link Control).

Octets Transmitted ± Number of octets (8 bit bytes) transmitted.

Frames Transmitted ± Number of frames (groups of data bits) transmitted. Octets Received ± Number of octets received.

Frames received ± Number of frames received.

Alloc failures on send ± Number of packets not transmitted because there was no memory available to build the packet.

Unknown Pkts Received ± Packet with unknown received.

Bad Checksum Packets Received ± Packet with a bad checksum received. Frame Errors Received ± Packet received with bad framing.

Other Pkt Errors Received± Packet received with an error not listed above.

Alloc failures Received ± Card was unable to allocate enough memory to receive the packet.

LCP Stats (PPP)

B-D-H (B)

 

 

Displays a summary of the Link Control Protocol (LCP) activity on a selected interface on the card. The screen is divided into two parts ± the left side is for the local end of the link; the right half is for the remote end of the link.

Interface name ± Enter the name of the desired interface (s1c, s1d, s1e, s1f).

Link Phase ± Current phase/state of this link (Init, Link Control, Opened).

Async Bit Map ± Coding used to embed PPP control characters in the data section of the packet.

Authentication ± Authentication type required for the connect to be accepted (usually none).

Magic number ± Unique number associated with this end of the link, used to ensure the link is not a loopback.

IPCP General Stats (PPP)

B-D-H (C)

 

 

Displays a summary of the IP Control Protocol (IPCP) activity on a selected interface on the card. The screen is divided into two parts ± the left side is for the local end of the link; the right half is for the remote end of the link.

Interface name ± Enter the name of the desired interface (s1c, s1d, s1e, s1f).

Link Phase ± Current phase/state of this link (Init, Link Control, Opened).

LCP Configuration ± Configuration of the link control protocol.

State ± State of the IP link (Initial, Opened, Closed).

IP Address ± IP address assigned to this end of the link.

7-28

November 1997

8000-A2-GB20-20

Page 116
Image 116
Paradyne 8546, 8540 manual Network Protocol Options 7, PPP Stats General H a, LCP Stats PPP H B, Ipcp General Stats PPP H C