Paradyne 8540, 8546 manual Configuring the HotWire Dslam, Port Naming Convention

Configuring the HotWire DSLAM

4

Overview

The HotWire DSLAM enables you to configure and manage the HotWire MCC and DSL cards. This chapter describes the basic card configuration instructions.

Port Naming Convention

The following is the naming convention used for the HotWire DSLAM interfaces:

NOTE:

Interfaces are sometimes referred to as ports. The term ports, however, usually is reserved for referring to the physical layer attributes of an interface.

He1a Ð Interface name of the DSLAM system 10BaseT interface on the MCC and DSL cards.

Hs1b Ð Interface name of the MCC and DSL card's interface to the DSLAM system backplane bus.

Hs1c, s1d, s1e, and s1f Ð Interface names of the four DSL ports on a DSL card.

NOTE:

These names are used throughout the remainder of this guide to reference the HotWire DSLAM interfaces. These are also the names used in the HotWire DSLAM software when configuring the HotWire DSLAM system.

8000-A2-GB20-20 November 1997 4-1