Paradyne 8540, 8546 Configuring 5446 RTU IP Host Addresses on the 8546 DSL Card

Configuring the HotWire DSLAM
4-12 8000-A2-GB20-20
November 1997
Configuring 5446 RTU IP Host Addresses on the 8546 DSL Card
Use this procedure to assign an IP address within the management subnet to
each 5446 RTU interoperating with an 8546 DSL card.
Procedure
To configure IP host addresses on the DSL card:
1. Select
Configuration → Interfaces → IP Network (A-C-B) .
2. Enter values for the following basic fields and press Return after each entry:
Field Description Input
IP Interface Name of the interface. s1c (8546 DSL interface)
Peer IP Address IP address associated with
the other end of the link; i.e.,
the 5446 RTU.
nnn.nnn.nnn.nnn format *
Route to Peer Routing method to use to get
to peer (i.e., host or net).
Host
*The subnet mask can be changed for the corresponding 5446 RTU. Refer to
Appendix F,
5446 RTU Setup.
NOTE:
The DSL interface is “unnumbered,” meaning it requires no IP address.
(This field is read only.)
The following fields also appear on the screen. These fields can be used to
customize your application.
Field Description Input
Input Filter Prevents packets from
entering the DSL card
through a specified interface.
Blank to disable.
Output Filter Prevents packets from going
out of the DSL card through a
specified interface.
Blank to disable.
3. Repeat the above procedure for interfaces s1d, s1e, and s1f (8546 DSL
Ports 2, 3, and 4, respectively).
4. Press Ctrl-z to return to the
Configuration → Interfaces menu.