Paradyne 8546, 8540 manual Configuring Static Routes to End Users on each DSL Card

Configuring the HotWire DSLAM

Configuring Static Routes to End Users on each DSL Card

Use this procedure to enable the management traffic from the 8546 DSL cards to the 5446 RTU and attached end-user systems. Use SNMP or the IP Injection Tool to download the needed enterprise MIBs and to configure static routes and service domain routes to end users attached to each 5446 RTU. Refer to Appendix F, 5446 RTU Setup.

NOTE:

Each time you create a static route for an end-user system behind an RTU, you should also create a corresponding source-based input filter rule. See Chapter 5, IP Address Allocation, Chapter 6, IP Routing, and Chapter 7, IP Filtering, of the HotWire DSLAM for 8540 and 8546 DSL Cards Network Configuration Guide.

"Procedure

To configure a static route to End Users:

1.Select Configuration → IP Router → Static_Routes (A-E-A).

2.Press Return on the Item 0 field to add a new record.

3.Enter values for the following fields and press Return after each entry:

Field

Description

Input

Host/Net

Destination of the route.

0.0.0.0to indicate the default route

Subnet Mask	Associated subnet mask	nnn.nnn.nnn.nnn format
	for the specified	On Model 8540, subnet
	destination IP address.
		mask must be
		255.255.255.255.
Next Hop (on Model	IP address of the next hop	nnn.nnn.nnn.nnn format
8546)	device for the specified
	destination.
Next Hop (on Model	DSL port name for next	Port name s1c, s1d, s1e,
8540)	hop.	or s1f.
Pref (Preference)	Measure of how preferable	The lower the number, the
	one route is to another, if	more preferable the route.
	you have two routes going
	to the same destination.
S/D (Source/Destination)	Source or destination route	Default = Dst
	type.
PA (Proxy ARP)	Router answers ARP	Default = No
	requests intended for
	another machine.

4.Confirm the save and press Ctrl-z to return to the Configuration → IP Router menu.

4-16 November 1997 8000-A2-GB20-20