Initial Settings

When the TV set is operated for the ﬁrst time, the Digital TV turns on ﬁrst.

Because this is the ﬁrst time the TV is used, there are no channels stored in the memory.

When the TV is turned on for the ﬁrst time, the menu for the language selection appears on the screen. The message “Welcome please select your language!” is displayed in all language options sequentially in the OSD.

By pressing the “” or “” buttons highlight the language you want to set and press OK button. After then, “First time installation” OSD will appear on the screen. By pressing “” or “” buttons, select the country you want to set and press OK button (* for EU countries).

Note: Country selection OSD will not be available for UK.

After then, the active antenna selection OSD appears on the screen:

By pressing “” or “” buttons, set active antenna mode as on or off.

Note: Country selection OSD will not be available for UK.

After then, the active antenna selection OSD appears on the screen:

By pressing “” or “” buttons, set active antenna mode as on or off.

If an active antenna is connected to your TV, you can select this option as On. Antenna power should be “Off” when standard antenna is used instead of the active antenna. See Conﬁguration Menu in the following sections for more information.

Press OK button on the remote control to continue and the following message will be displayed on the screen:

•To select the “Yes” or “No” option, highlight the item by using “” or “” buttons and press the OK button.

The Digital TV will automatically tune to the UHF or VHF(*) (* for EU countries) transmission channels, searching for digital terrestrial TV broadcasts and displaying the names of channels found. This process will take about a few minutes.

After Automatic Search is completed, the following message asking for analogue channel search appears on the screen:

To search for analogue channels, select “Yes”. TV switches to the analogue TV mode. Analogue search menu will be displayed.

Select your Country, Language and Text language by using “” or “” and “” or “” buttons. Press OK or RED button to continue. To cancel, press the BLUE button.