>Use the arrow keys to mark the selected programme.
>Press the red function key.
The selected entry will now be displayed in red.
Your receiver will be switched on at the time when the selected programme is due to begin. If the receiver is switched on by the timer, the letter "t" will be shown on the display, together with the channel number. In this mode, most of the functions of the remote control are disab- led in order to prevent an accidental premature interruption of the recording.
If the receiver is in standby mode, the activated timer will be indicated by blinking of the two dots (colon) in the time display.
>Press the Back key to return to the previous display.
Disabling the timer function
If you want to cancel a timer command entered via the EPG, repeat the above steps, then cancel the timer setting by pressing the red function key.
In order to interrupt/disable while the timer is actively in operation, switch off the receiver by means of the on/standby key. When you press this key again, the receiver will be switched
on, and you can continue with normal operation.
6.13.7.4 EPG Summary
You can use the EPG Summary in order to display the current day's programme of a single channel. This can be done as follows:
>Press the EPG key.
The EPG table Now/Current will be displayed
>Press the green function key.
The table EPG Summary will be displayed.
>Use the up/down arrow keys to select the required programme resp. time.
>If available, the left/right arrow keys can be used to display the programme con-
tents for the next few days.
.
25
