TechniSat ST 6002 S manual Programming of Future Satellites

TechniSat ST 6002 S

Return the cursor to "Sat" and use the buttons to select the satellite which you wish to store next. Repeat the same procedure as described above. All satellites can be stored by this method.

NOTE: Not all satellite channels are transmitting continuous- ly. Additionally, it may also be necessary to alter the "Skew" values depending on the polariser type (refer to later section on "Changing Channel Parameters").

Programming of Future Satellites

1.If you wish to store a new satellite which is not already pre- set, you can choose an already stored channel with a frequency which is nearest to the frequency of a channel on the new satellite. The polarisation and LNB type must also be taken into account. After entering the required data, move the cur-

sor to “Position” and move the dish using the keys until you receive the desired channel.

2.Now move the cursor to “Sat” and select a satellite which is not already stored (Spare 1-32). The channel selected pre- viously can no longer be viewed. Move the cursor to “Pos” and press followed by ENTER on RCU. The satellite is now sto-

red. To store the channels on this satellite it is necessary to follow the procedures set out in the section on “Channel data".

E N T E R

16