TechniSat ST 6002 S manual Changing Channel Parameters 8.6.1. Video Menu

TechniSat ST 6002 S

8.6 Changing Channel Parameters

8.6.1. Video Menu:

To change the present video parameters first press the VIDEO button on the RCU. The video menu appears on the screen. Now you can change the following parameters:

"IF tune"	-	IF (950 - 2050 MHz) which can be
		keyed in directly
"B/W"	-	Video bandwidth, 18/27 MHz selec-
		table. Switch to narrow (18 MHz)
		for reception of weak signals.
"Level"	-	You can alter the video level (1 - 4) to
		change the channel brightness.
"Video-Pol"	-	You only change the video polarisation
		to "inverted" for C-band reception or for
		some special decoders.
"Decoder"	-	If you wish to connect a decoder to your
		ST 6002 S, switch to "External". Then
		the coded reception signal will be sent
		from the VCR/Dec. scart socket to the
		decoder. The decoded signal will be sent
		back to the receiver and can be picked
		up at any output.
		If you have chosen "External", you can
		select between 4 different decoder sig-
		nals depending upon the decoder being
		used.
		You can also switch to "External" if you
		wish to throu-loop the playback of a video
		recorder to your TV.

If you wish to store the changes, leave the video menu using

ENTER. If not, press CNCL.

NOTE:

The respective signal strength is also displayed on the screen. The weaker the signal is, the greater the negative value.

37