Performance Verification
32 P5205 Instruction Manual
15.Set the calibration generator for 10 V output.Set the attenuation
button on the probe to 50X (in).
16.Rec ordt he DCam plitude of the square wave (∼10V) and divide
1/100th of this intoonly the amplitude of the oscilloscope (refer
to step 6). Verify that only the probegain accuracy is ᐔ3%.
17.Reduce the amplitude on the generator to minimum then disable
the generator output, leaving the setup c onnected for the next
procedure.
Bandwidth1. Connect the Modified BNC adapter through a 50 Ωterminator to
the leveled sine wa ve output of the generator (AUX, Si ne,
50 Ωload).
WARNING. Toreduce the risk of electric shock, ensure the generator
output is disabled before modifying/disconnecting test setup or
connections since exposed metal may at a hazardous potential. It is
recommended that the generator output amplitude be reduced to
minimum prior to disabling the output.
2. Attach the differential probe input leads (without attachme nt
accessories)by sliding the banana plug of the leads onto the
binding posts metal sleeves on the Modified BNC adapter (see
Figure 13 on page 31).
3. Set the bandwidth on the probe to FULL and the attenua tion
button to 50X.
4. Set the Volts/Divisionon channel 1 of the oscilloscope to
500 mV,and sec/di v to 20 s.Set the trace to the center of the
oscilloscope.
5. Reduce the amplitude on the generator to minimum the ne nable
the output.
6. Set the sine wave generator to 50 kHz, and adjust the amplitude
to 3.00 V as measuredon the oscilloscope.