5.If applicable, install optional digital metering control module in place of standard control module. (See instructions included with metering control module.)

6.Partially thread two topmost fasteners (#12-20 screws, provided) for mounting panel onto bay.

7.Place panel’s keyhole mounting slots over topmost fasteners.

8.Loosely secure the mounting flange with four additional fasteners along each side.

9.Torque all but keyhole mounting fasteners to 35 in.-lb (4.29 N•m).

10.Remove keyhole fasteners installed in Step 4, and re-install along with a flat washer and a lock washer. Torque as directed in Step 9.

11.Install all other panels in bay before cabling.

CABLE INSTALLATION

Use Telect’s Wire Size Guide (117995) for help in cable selection.

NOTE

Cables must conform to local operating company guidelines as well as national, regional, and local electrical codes.

Only use components and crimping tools approved by agencies or certifying bodies recognized in your country or region such as Underwriter’s Laboratories (UL), TUV, etc.

Telect, Inc. • USA +1.509.926.6000 • Mexico +1.52.33.3836.3700

 

Poland +1.48.713.239.100 • UK +1.44.1489.889500 • www.telect.com

Page 2-4

Copyright © 2002 Telect, Inc., All Rights Reserved