Telenetics CDMA manual Chapter Installation, Installation Summary

Chapter 2

Installation

This chapter describes how to install the OMEGA CDMA Modem.

Installation Summary

Installing the OMEGA CDMA Modem involves the following steps:

1.Unpack your OMEGA CDMA Modem. See page 11.

2.Obtain the additional items you need for installation. See page 11.

3.Obtain cellular telephone service. See page 11.

4.If you have the stand-alone OMEGA CDMA Modem, attach the mounting feet. See page 12.

5.Install the optional RS-232 module, if appropriate. See Appendix B.

6.Connect the OMEGA CDMA Modem to a power supply. See page 12.

7.Set the OMEGA CDMA Modem DIP switch. See page 12.

8.Use the pre-programmed Telephone/Mobile Identification numbers to have your RTU originate calls to its host via the RS-232 Data Terminal Ready (DTR) signal. See page 14.

9.Attach an RS-232 cable. See page 14.

10.Power-up the OMEGA CDMA Modem. See page 16.

11.Verify that the OMEGA CDMA Modem can answer incoming calls. See page 16.

12.View the OMEGA CDMA Modem’s current configuration. See page 16.

Page 10