AT Commands
Table
AT Command | Parameter | Description |
*? |
| Display list of OMEGA commands. |
*CLIENT= | 0 | Disable Client mode. |
| 1 | Enable Client mode. |
*CLIENT? |
| Display Client mode activation. |
*D= [string] |
| Set auto dialup string. |
*D? |
| Display auto |
*DIP [xxx.xxx.xxx.xxx] |
| Connect to given IP address. |
*DTR | 1 | Enable DTR dialing. |
| 0 | Disable DTR dialing. |
*DTR? |
| Display DTR dialing activation. |
*F |
| Restore the default OMEGA configuration. |
*H |
| Hang up the modem connection. |
*HIP |
| Hang up the active IP connection. |
*I |
| Display the controller firmware version. |
*IPR= [baud] |
| Set the |
*IPR? |
| Display the |
*LIP= [xxx.xxx.xxx.xxx] |
| Set the local IP address. |
*LIP? |
| Display the local IP address. |
*LOOP |
| Enter loopback mode. |
*LPASS= [string] |
| Set the local password. |
* LPASS? |
| Display the local password. |
*LUSER= [string] |
| Set the local username. |
*LUSER? |
| Display the local username. |
*MAC= [string] |
| Set the controller MAC address or telephone number. |
*MAC? |
| Display the controller MAC address or telephone number. |
*MRU= [number] |
| Set the |
|
| Unit (MRU). |
*MRU? |
| Display the PPP MRU. |
*NETSTAT |
| Display network statistics. |
*PING= [xxx.xxx.xxx.xxx] |
| Ping the specified IP address. |
*PORT= [number] |
| Set the TCP and UDP listen port. |
*PORT? |
| Display the TCP and UDP listen port. |
*PPP= | 1 | Enable PPP. |
| 0 | Disable PPP. |
*PPP? |
| Display PPP activation. |
*R= [secs] |
| Set the transceiver |
*R? |
| Display the transceiver |
*RESET |
| Restart the system. |
*RIP= [xxx.xxx.xxx.xxx] |
| Set the remote IP address. |
*RIP? |
| Display the remote IP address. |
Page 22