Remote Control Console

13

7 Setup Mode

7.1 Tech Mode

The tech mode allows a technician to program the internal settings of the C-2002 console. The tech mode is entered

by pressing MUTE-F6-*simultaneously. The technician will be required to enter a PIN number to allow entry. See the section 7.4.4.1 on setting up the PIN number. The Opening Menu is displayed when tech mode is entered. In addition to the information on the display you will visual see the MON, SEL 1-2, MUTE 1-2, F1-F8, SUP and the ALERT buttons also flash indicating you are in the tech mode of operation. These buttons also provide setup options when pressed, refer to sections 7.6 and up for additional information.

7.1.1Erasing all settings

All of the settings in the console can be reset to factory defaults by pressing and holding both “IC” and “*” and then applying power. The screen displayed asks if the user wants to restore defaults or not.

Restore Defaults?

YES

NO

PROG1 PROG2

PROG3 PROG4

PROG1 - Answer, YES and you will clear all settings to the factory defaults.

PROG3 - Answer, NO and you will enter the user mode.

7.1.2Resetting the PIN Number

In the event the PIN number is either forgotten or not known, the test jumper J15 on the main board inside the unit can be used to enter a self test mode and reset the PIN. With the power removed from the unit, move J15 to the “B” position on the board. Power up the board. The PIN number is cleared allowing immediate entry into the tech mode. Power down the board and move the J15 back to the “A” position. Close the case and resume normal operations with the C-2002.

Page 19
Image 19
Telex C-2002 technical manual Setup Mode, Tech Mode, Restore Defaults?, Erasing all settings, Resetting the PIN Number