Remote Control Battery
The remote control requires one 9V alkaline battery installed as shown in Figure 10.
Figure 10. Remote Control Battery Installation
1.SLIDE THE BATTERY COVER BACK AND LIFT OUT.
2.PLUG IN THE BATTERY AND POSITION IT IN THE BATTERY COMPARTMENT.
MINNEAPOLIS, |
| MINNEAPOLIS, |
| ||||
P/N: | 47436 |
|
| P/N: | 47436- MN |
| |
| - MN |
|
| U. | |||
9VDC | U. | 9VDC | XXX | ||||
|
| XXX |
|
| S. | ||
|
|
| S.A. |
|
|
| A. |
OPEN
3.ALIGN THE TABS ON THE BATTERY COVER WITH THE SLOTS IN THE BACK CASE AND
REPLACE THE COVER.
| MINNEAPOLIS, | ||
OPEN | P/N: | 47436 |
|
| XXX U. | ||
| 9VDC | - MN | |
|
|
| S.A. |
4.CHECK THE OPERATION BY PRESSING ANY KEY. THE LED INDICATOR SHOULD BLINK RAPIDLY.
STANDBY
FOCUS
SOURCE
MODE
MENU
A new battery should be installed in the remote control unit under the following circumstances:
∙New remote control unit is received from the factory.
∙LED on the remote control no longer lights when keys are pressed, indicating a “dead” battery
∙Operating distance between the remote control and the P350 becomes too short for your purposes, indicating a “weak” battery
Continue with the Operation section of this manual for instructions on the use of your Firefly™ P350 LCD Notebook Computer Projector.
User Manual 11
