Tiger Products Co., Ltd JD 5083E MAINTENANCE WEEKLY OR EVERY 50 HOURS, MONTHLY OR EVERY 150 HOURS

MAINTENANCE

WEEKLY OR EVERY 50 HOURS

ITEM		SERVICE		COMMENTS
In Tank Hyd. Fluid Filter		Change		Change after the first 50 hours only,
(10 micron filter)				then every 500 hours, yearly or if
				indicated by the restriction indicator.
In-Line High Pressure Filter		Change		Change after the first 50 hours only,
(10 micron filter)				then every 500 hours, yearly or if
				indicated by the restriction indicator.
Chain Coupling		Check
MONTHLY OR EVERY 150 HOURS
Hydraulic Fluid Level		Check		Add as needed
Hyd. Tank Breather	Clean/Check/Replace			Clean or replace element as required
YEARLY OR EVERY 500 HOURS
Spindle Grease		Change
Hyd. Tank Fluid		Change
In Tank Hyd. Fluid Filter		Change
(10 micron filter)
In-Line High Pressure Filter		Change or		Change when indicated by restriction
(10 micron filter)				indicator.
Hyd. Tank Breather		Change
	TROUBLE SHOOTING
SYMPTOMS		CAUSE		REMEDY
Vibration	1.	Loose bolts	1.	Check all bolts and tighten to
				torque specs. in this section
	2.	Cutter assembly	2a. Check for damaged blades, disc.
	Unbalanced			or cutter shaft. Replace if needed.
			2b. Check for wire, rope, etc.
				entangled in cutter assembly
Mower will not lift	1.	Hyd. Fluid low	1.	Check and refill Hyd. Fluid
	2.	Leaks in line	2.	Tighten or replace fittings and hoses
	3.	Faulty relief valve	3.	Check pressure in line. Line
				pressure in Control Valve
				should be at least 2500 P.S.I.
	4.	Kinked or blocked	4.	Clean or replace line.
	5.	Faulty cylinder	5.	Inspect, repair or replace cylinder
Mower will not start	1.	Blown fuse	1.	Check fuse between mower switch
or run				and ignition / replace
	2.	Ball valves closed	2.	Make sure valves are open
	3.	Low oil level	3.	Check Hyd. tank and fill
	4.	Line leak	4.	Check all fittings and lines,

Cheetah Maintenance Section 4-4