28 ServiceSearch
Youcan search only services of a specific transponder because
more than one service are providedvia one transponder. To
do that, set the Search Mode option to Manual, and then se-
lect your desired transponder at the Channel option. The
transpondernumber ranges from 5 to 12 in VHF and 21 to 69
inUHF.
Tosearch one service of a transponder, set the Search Mode
optionto Advanced, and specify the PIDs of your desired ser-
vice at the PID option with the numeric buttons. PID (Packet
Identifier) is a set of numbers that identifies transport stream
packets.
Tostart service search, select the Start Searchitem; then ap-
pears a list box, in which found services will be listed. Press
the
OK button to save found services when it is completed.
Tostop at any time, or to exit without saving, press the
EXIT
button.
4.2 Resetting to factory settings
Thedigital receiver maintains the following data:
• Service list
• Favorite list
• Timer list
• Preference settings
Youcan reset all data of the digital receiver. If you want to re-
setall the data, select the Installation >Factory Setting menu,
thenyou are asked for confirmation. Ifyou select Yes, service
entries, favorite entries and timer events will be all deleted,
andpreference options will be reset to the manufacturer’s fac-
torysettings.
The digital receiver will ask for your location and language
afterresetting all the data. Youhave to designate them so that
youcan perform service search again.