Toro SA41 owner manual Introduction, Warranty Card, Installation

INTRODUCTION

Thank you for purchasing the Selectronic Sine wave inverter, model SA41 with ENERGY MANAGEMENT.

Your SA41 is a state-of-the-art high performance TRUE SINE WAVE DC to AC Power Inverter incorporating ENERGY MANAGEMENT, a unique energy monitoring and controlling system developed by Selectronic to enable you to maximise your limited energy resource.

Thousands of hours of development time have been invested in the SA41 to provide you with a reliable, high quality product. The output from your SA41 is as good as, if not better than mains power and if looked after properly, the SA41 will give you many years of reliable service.

WARRANTY CARD

Before proceeding any further, it is extremely important that you complete your warranty card NOW. This will enable us to immediately register your initial 24 month warranty period, and also make you eligible for our free lifetime warranty extension. Six months after the purchase date of the SA41, Selectronic will send you a questionnaire. Simply complete and return the questionnaire to us and we will extend your warranty, free of charge, for a lifetime. By accurately completing your warranty card and questionnaire, you will provide us with valuable information that will assist us in keeping up with your alternative energy needs. Please take a few moments to fill in the warranty card. Your efforts will be greatly appreciated.

INSTALLATION

300mm

The installation of your inverter is								SELECTRONIC SINE WAVE INVERTER
extremely		important.		Failure		to
follow		the	recommended
installation		instructions		may	void			WITH ENERGY MANAGEMENT	SA41
your	warranty.		If in	doubt,		ask		DC TO MAINS POWER	PROUDLY DESIGNED & MADE IN AUSTRALIA
your supplier.
After unpacking the SA41, check								200mm
for any damage which may have
occurred during transit. If there are
any signs of damage, contact your
supplier immediately.
The inverter must be installed in a							300mm		300mm
dry, cool, dust-free environment.
Please leave at least 300mm
clearance at the left and right hand
sides	(Black		heatsink		fins),
300mm above the inverter and								Front
approx. 200mm at the rear as this

will aid the natural cooling of the inverter. The air vents on the underside of the SA41 also need to be kept clear of obstructions.

2