Appendix II Flow Diagram for Displays and Settings | Toro SA41

APPENDIX II: FLOW DIAGRAM FOR DISPLAYS AND SETTINGS

READINGS

Status: STANDBY

Inverter: OFF

MON: 15:06

---Readings---

AC Volts: 240V

---Readings---

AC Amps: 2.5A

---Readings---

Batt Volts: 49.2V

---Readings---

Current Shunt

Not Installed

Amps: 23.6A OUT

---Battery---

Pk Amps: 45.6 IN

---Battery---

Net AH: 69 IN

---Today---

Charge: 87%

--In Battery--

21

Image 21

Toro SA41 owner manual Appendix II Flow Diagram for Displays and Settings, Readings

Contents

Selectronic Australia Warranty Card InstallationIntroduction Supply Connection of AC and DC Wiring RED = Battery Positive + Black = Battery Negative Operation Status Standby Inverter OFF Inverter on Status ResetEnergy Management Status Where the Optional 200 AMP Current Shunt is Installed Minimum Charge Settings Controller OutputsOn with OFF Set Control On with on On with Time Set Control Duration Lockout Buzzer on / OFF More SettingsBuzzer Lockout SET DAY Lockout Alarm Inputs AC Volts SettingAlarm Input Current Shunt Settings External Shunt Charge in Battery Battery CapacityMinimum Charge in Battery LOW Charge Alarm Overload Shutdown and Alarms Alarm 1 Active Fault FindingAlarm 2 Active Heatsink TOO HOT Inverter Shuts Down with LOW Volts System Maintenance SA41 MaintenanceBattery Maintenance Demand Start Section SA41 Electrical Specifications Handy Hint Radio Frequency Interference Transformer Temperature Appendix I DiagnosticsHeatsink Temperature Demand Start Current Appendix II Flow Diagram for Displays and Settings Diagnostic Displays Switching Between READINGS, Minimum CHARGE, and DiagnosticsMinimum Charge Display Minimum charge Displays CO+LAH INV CO, LO A/H or From previous Appendix III SA Inverter Options GeneralSA-SB-01 Interface KIT SA-SB-01 Interface Connections Alarm Inputs Examples Ext. Keypad no Set Parameters Installation of SA-KP-01 Optional Keypad Amps 0.0A OUT Battery Installation of SA-S200 Optional Current ShuntExt. Shunt no Set Parameters Zero DC Amps OFF Set Parameters Product Warranty Conditions Mounting Template for SA-KP-01 Keypad