READINGS
The SA41 ENERGY MANAGEMENT has six "Readings" displays to give you vital information about your inverter and your batteries. By pressing the 'NEXT DISPLAY' key on the front panel, the screen information rotates through displays of inverter Status, Time, AC Volts, AC Amps and Battery Volts. When the optional current shunt
TIME
Mon : 15:06
- - - Readings - - -
Displays the Current Time (as a 24Hr clock) and day. This time is set as described in "Settings" (see Page 8).
AC VOLTS
AC Volts : 240V
- - - Readings - - -
AC AMPS
This screen gives an approximate indication of the AC voltage produced by the inverter. The AC volts would normally read between 230V and 245V except under high load or low battery conditions.
AC Amps : 2.5A
- - - Readings - - -
The AC current reading shows the total current drawn from the AC output by the appliances connected to the inverter.
BATTERY VOLTS
Batt Volts : 49.2V
- - - Readings - - -
Displays the DC Battery volts. This provides you with an indication of the condition of your battery bank.
WHERE THE OPTIONAL 200 AMP CURRENT SHUNT IS INSTALLED:
DC CURRENT
Amps : 23.6A OUT
- - - Battery - - -
PEAK AMPS
This reading gives a Nett current; i.e., either charging the battery (IN) or being taken out of the battery (OUT). The range for this reading is
Pk Amps : 45.6 IN
- - - Battery - - -
This reading gives the peak Nett charging current into the batteries for the present day (today). If no load has been present for the entire day, this will indicate the peak combined charging current from your solar panels, wind generator or other charging sources, thus allowing you to monitor their operation. During the first day after the inverter is turned on at the circuit breaker, this screen will display a meaningless figure.
6
