Status of the UPS, measurements, and alarms are all indicated on the LCD screen.
Figure 3 Control panel
Normal Display
The UPS status is shown in the normal display mode. The UPS Meters display and the Setting display may be accessed by pressing this button.
UPS Meters Display
Listed below are the parameters available for viewing from the UPS meters display. Press this button to scroll through the parameters.
LCD Message | Description |
O/P VOLT= xxx.xV | Shows Output AC Voltage |
O/P FREQ= xx.x Hz | Shows Output Frequency |
I/P VOL T= xxx.xV | Shows Input AC Voltage |
I/P FREQ= xx.x Hz | Shows Input Frequency |
BAT VOLT= xx.xV | Shows Battery Voltage |
O/P LOAD%= xx% | Shows Load % of Max Load |
O/P W= xW | Shows Output Watts |
O/P VA= xVA | Shows Output VA |
O/P CURR= xA | Shows Output Current |
BACKUP TIME= xx min | Shows Estimated Backup Time in Minutes |
BAT CHARG= xx% | Shows Approximate Percentage of Battery Capacity |
TEMPERATURE= xxC | Shows Approximate Ambient Temperature |
BAT PACK NUM= x | Shows External Battery Pack Number |
RATING = xxxxVA | Shows UPS Rating |
CPU VERSION xx.x | Shows CPU Version |
22
