Initial Setup
When you first rum on or reset the TV, the Initial
Setup window will appear.
1In the Menu Language field, press _ or _ to
select your preferred lan_lage.
2Press • or • to select Time Zone Setup and set
your desired time zone with _ or _ and press
0
3Next, the Location setting window will appear.
For normal home use, press @ to select Home.
4Next, ANT/CABLE in setup window will appear.
Press _ or _ to select the input source (Cable or
Antenna) for the ANT/CABLE input on the TV.
5If you select Antenna, the Channel Tuning Mode
setup window will appear. To tune only digital
channels, select Digital. To rune digital channels
preferentially over analog when entering channel
number directly, select Auto. For normal tuning,
select Standard. Press @ to continue to Auto
Tuning.
6Press @ to select Start Scan and continue with
the Auto Tuning.
You can stop the Initial Setup with E_T. However if
you do not finish the entire Initial Setup process, the
Initial Setup window will appear every time you turn
on the TV.
Selecting the menulanguage
You can choose from three different lan_mges
(English, French, and Spanish) forthe on-screen
display of menus andmessages.
To select the menu language:
1Press u_u and open the Preferences menu,
highlight Menu Language.
2Press _ or _ toselect your preferred menu
lan_mge.
24
3Press E_Tto close the Preferences menu.
Configuring the antenna input
source for the ANT/CABLEterminal
To configure the ANT/CABLE input source:
1Press M_uand open the Setup menu.
2Highlight Installationandpress _.
3(Anew setof Installation menu iconswill appear,
as shown below.) Open the Terrestrial menu,
highlight Input Configuration, and press @.
4Highlight ANT/CABLEInand press _ orI_ to
select the input source (Cable or Antenna) forthe
ANT/CABLEinput on the TV.
5To save your new settings, highlight Dogeand
press @. To revert to your original settings,
highlight Cancel and press @.