4. Register Configuration
CH1 receive length (19) and
CH2 receive length (83)
The address 19 (for channel 1) and the address 83 (for channel 2) indicate the length of the received message (number of bytes). This information is set during the received message read sequence.
19 or 83
F | E | D C | B | A | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
Received message length
Bit
Received message length
Shows the received message length (bytes). 0 - 896
CH1 trailing code (24) and
CH2 trailing code (88)
The address 24 (for channel 1) and the address 88 (for channel 2) store the trailing codes. The default setting is H0D (CR code).
To change the trailing code, write the desired code into this address then write the hot reset command into the Command 1 (12). See section 5.6 for this procedure.
24 or 88
F | E | D | C | B | A | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
0 | 0 | 0 | 0 | 0 | 0 | 0 | 0 |
|
|
| Trailing code |
|
|
| |
Bit
Trailing code
Stores the trailing code.
Initial value at power on is H0D (carriage return).
34 ASCII Interface Module (AS311)
