Toshiba AS311 user manual Setting the trailing code, Operation Procedure, H0003, H80FE

5. Operation Procedure

5.6 Setting the trailing code

The default setting of the trailing code is CR (carriage return code = H0D). The trailing code can be changed by T3 program.

To do this, write desired trailing code into the AS311’s buffer memory address 24 (CH1 trailing code) and/or address 88 (CH2 trailing code), and execute the hot reset (refer to section 5.5).

A sample program is shown below. This sample program is for the AS311 that is allocated to XW000 - YW003.

In this sample program, the trailing code changing routine will be executed once when the AS311 status is changed to ready (R0100 comes ON - refer to section 5.4), and the channel 1 trailing code will be changed to H03.

If the channel 2 trailing code and/or the time-out check time are also changed, write these data on the Main program Rung 2 before calling Subroutine No. 3 in the same manner.

(Main program)

(H0003)

(Subroutine No. 3)

(H80FE)

User’s Manual 49