ICC

5)You should now see the new module (named “ETHERNET-MODULE ASD_G9ETH”) in the 1756-ENET/B branch under the I/O Configuration in the controller organizer view. Right click on this new module, choose “Properties”, and select the Connection tab. Refer to Figure 68.

Confirm the setting of the Requested Packet Interval (RPI). The RPI defines the amount of time (in milliseconds) between data exchanges across an I/O connection. The smallest RPI supported by the interface card is 10ms.

Click OK when done.

Figure 68: Module Properties Connection Tab

6)After adding the I/O Module to the configuration, the full I/O Configuration tree should appear similar to Figure 69.

7)Switch to online mode and download the project to the PLC. Verify that the newly-added drive is available and operating correctly by observing any indications shown on the drive’s icon. When the drive’s icon is selected, its status and any available error messages will be displayed in the area below the project tree. Refer to Figure 70. Also confirm that the interface card’s “Network Status” LED should be

Figure 69: I/O Configuration Tree

Figure 70: Online Module Status

72