Toshiba B-570-QP Series owner manual Media, Ribbon, Type Spool type Width

2. SPECIFICATIONS

ENGLISH VERSION EM1-33031

2.3 Media

2.3	Media		Label			Refer to the following	Tag paper
						NOTE 2.		Black Mark
						Black Mark
	Stop	I				(on reverse side)	I	(on reverse side)
						Stop		Tag paper
	position
						position
					E	Cut		F
	Cut
	position					position	Reference
			Reference
		J		1		A	coordinate 1	A
		H	coordinate		B		H
			Reference				Reference
			coordinate	2			coordinate	2
			G			Feed direction	G
			D
							C
			C
						Fig. 2-1		[Unit : mm]

Item	Label dispensing mode				Batch mode			Strip mode		Cut mode
A : Span of one label/tag					10.0 ~ 999.0		25.4		~ 999.0	Label: 38 ~ 999.0
										Tag: 25.4 ~ 999.0
B : Label/tag length					8.0 ~ 997.0		23.4		~ 997.0	25.0 ~993.0
C : Width including backing paper							50.8		~ 140.0
D : Label width						47.8			~ 137.0
E : Gap length					2.0 ~ 20.0			2.0	~ 20.0	6.0 ~ 20.0
F : Black mark length (Tag paper)						2.0			~ 10.0
G : Effective print width						10.0			~ 128.0
H :		Label	Standard		6.0 ~ 298.6			21.4	~ 298.6	23.0 ~ 298.6
Effective print			Max. memory		6.0 ~ 995.0			21.4	~ 995.0	23.0 ~ 991.0
length		TAG	Standard		8.0 ~ 298.6			23.4	~ 298.6	234.0 ~ 298.6
			Max. memory		8.0 ~ 997.0			23.4	~ 997.0	23.4 ~ 997.0
I : Print speed up/slow down area									1.0
J : Black mark length (Label)						Refer to the following NOTE 2.
Maximum effective length				Standard		149.3
for on the fly issue				Max. memory		661.3
Outer roll diameter								ø200 Max.
Thickness	Label					0.13 ~ 0.17
	Tag					0.15 ~ 0.29

NOTES: 1. The media specification other than above are unchanged.

2.When marking black marks on label rolls, the following requirements must be satisfied. When the gap length is less than 4 mm:

The black mark length should be longer than the gap length. When the gap length is 4 mm or more:

The black mark should not overlap the gap for more than 4 mm and the following label.

2.4 Ribbon

Type	Spool type
Width	68 mm ~ 134 mm
Length	600 m
Outer diameter	ø90 mm (max.)

NOTES: 1. "On the fly issue" means that the printer can draw and print without stopping between labels.

2.To ensure print quality and print head life use only TOSHIBA TEC specified media and ribbons.

3.When using the cutter ensure that label length B plus inter label gap length E exceeds 35 mm. (i.e. label pitch should be greater that 35 mm.)

4.When rewinding the media onto the take-up spool in batch mode, the max. outer roll diameter should be 180 mm.

5.Use of rough media for the ribbon saving issue may cause ribbon smudges.

E2-2